THIS IS NOT JUST A RESISTOR OR SMD COMPONENT CHANGE AS THOSE ONLY LAST A YEAR
THIS IS A UPGRADE REVISION TO THE MOTHER BOARD AND POWER SUPPLY TO LAST FOREVER
AND TAKES UP TO 6 PARTS TO COMPLETE
AND USING PARTS WITH BETTER VALUES
Is your Synology Disk Station broken? Common Problems are: DEAD UNIT It no longer comes on and does not respond to the power button. It switches itself off and on? LEDs only flash and it won't boot? Blue Power LED flashes but no response afterwards? HDDs are not recognized? Unable to access web interface? And all other bugs as well! Your repair is carried out here inhouse by SMD trained electronic technicians. During the repair, the mainboard and the power supply are not only repaired, but also revised and checked for any series-typical errors. This is not just a repair.
This is a revision/repair!
Additional SMD components and components with corrected and or better values are used here.
This means that these errors should no longer occur in the future for the lifetime of the unit. This repair includes a few FETS, and a few resistors to be replaced. All repairs will get these parts. No Exceptions. And we even protect your unit with Kapton Tape covering future possible Cage Cable Cuts. And we put on Arctic Silver Thermal Paste for your Heat Sink. Some SMD parts the size of a grain of salt have to be replaced. We have the tools and the know how.
THIS IS NOT A SIMPLE 100OHM RESISTOR FIX BUT A MAJOR REVISION OF THE POWERING SYSTEM INSIDE AND MAY INCLUDE CORRUPTED BIOS ISSUES In addition, the CMOS System Battery is changed and the device is meticulously cleaned internally. Including fans, PCB's, cage, etc. We have spent hours on researching and reengineering our technique to perfect these repairs. There is nobody else in the world able to complete this kind of repair. And we make it to last forever!
Synology would hate that you fix yours. They would rather you buy a new one. But why? Let me fix your NAS.
We have spent time and time again reverse engineering this product to not only repair it, but to make it last a lifetime for you.*
We even give it a 1 Year Guarantee Repairs take about 1-2 working days in-house. Due to COVID restrictions some parts may be delayed slightly. Express service and express shipping possible on request. Cables, hard drives and hard drive trays are not required and remain with you.
Your data is therefore safe.
So far, each of the stations sent in to me for service since 2017 have been successfully repaired with 0 complaints. 0 returns.
And that's 100's of units. Therefore we give a 1 Year Guarantee on our repairs. We are the only team in the USA(and in Europe too) who does this, and this type of repair service.
PLEASE NOTE: If you do not want to have your station repaired, I would be happy to make you an offer to purchase your intact or defective station. Price is a flat rate repair service. Price is for Service, Repair and all Parts Serviced. Does not include shipping to and from our shop. Thank You!
* Lifetime on mother board only. Under normal use is the normal product life cycle, and beyond, and may be even more of that outside of physical damage to the unit.
EACH UNIT GETS ALL NEW PARTS!
NO LESS THEN WHAT IS SHOWN ON THE PICTURE ABOVE. SOME PARTS THE SIZE OF A GRAIN OF SALT NEEDS TO BE SOLDERED ON YOUR UNIT.
MOTHERBOARD IS CLEANED AND CHECKED FOR COLD SOLDER JOINTS. EACH UNIT IS TESTED WITH COMPLAINCE TESTING PROCESSES USED IN THE FACTORY.
EACH UNIT GETS ALL NEW
THERMAL PASTE AND A NEW COIN CELL BATTERY, AND IS THOUROUGHLY INSPECTED PRIOR TO SHIPPING.
EACH UNIT ALSO GETS WIRE PROTECTION TO PREVENT CUTS AND SHORTS. THE POWER SUPPLY ALSO GETS A FEW NEW PARTS PLUS A RESOLDER OF MAIN CONNECTIONS.
Second,
WE GUARENTEE OUR WORK FOR 1 FULL YEAR
PLEASE READ THIS MESSAGE
DO NOT USE THE PAYMENT BUTTONS BELOW, AS THEY ARE STUCK IN MY HTML FOR SOME REASON, AND I HAVEN'T CLEARED IT YET. YOU DO NOT PAY A DIME UNTIL YOUR UNIT IS FIXED!